Do I need a door, or can a walk-in shower stay open?

Many walk-in showers use a fixed panel with no door, which keeps the room open and removes a hinge to clean. The tradeoff is thermal rather than structural: an open entry lets warm, wet air into the rest of the bathroom, and in a marine climate that moisture has to be exhausted rather than left to settle on the finishes. We size the fan accordingly and plan the entry so water still lands where it should.

Is a frameless glass enclosure harder to maintain than framed?

Frameless is easier to keep clean because there is no metal channel for water and soap to collect in. What matters more here is your water: Camas runs on municipal groundwater and much of outlying Clark County is on private wells, and dissolved minerals are what leave the film people mistake for permanent clouding. A squeegee after use handles most of it, and a protective coating helps water sheet off.

What keeps a walk-in shower from leaking over time?

The waterproofing under the tile does the work, not the tile. Tile and grout are both water-permeable, so the membrane behind them is what actually protects the framing. That matters more in Clark County than in a dry climate, because a wall cavity that takes on moisture here has no hot, dry season in which to recover — Marine 4C keeps outdoor humidity high from late fall through spring.

Bathroom & Shower Services

Custom Walk-In Showers

A walk-in shower turns wasted square footage into the centerpiece of the bathroom — but in this climate the part that decides whether it lasts is entirely hidden. Clark County sits in climate zone Marine 4C, where the outdoor air stays near saturation from late fall through spring and a wall cavity that takes on moisture gets no hot, dry season to recover in. We build the waterproofing as a continuous membrane and size the exhaust to the room rather than to code minimum, then choose the tile, glass, and fixtures around how you actually use the space.

What's included

Walk-In Showers

Continuous waterproofing membrane across the pan, walls, seams, and penetrations
Exhaust sized to the room — Washington code sets a 50 CFM floor, not a design target
Frameless or semi-frameless glass enclosures sized to your space
Built-in niches and benches placed where you actually reach for them
Linear and center drains, with the pan sloped and flood-tested before tile

Frameless walk-in shower with large-format stone tile, dual brass rain heads, a built-in niche, and a low-threshold entry

How it works

Our walk-in showers process

The right choice for homeowners who want an open shower that is easy to step into and easy to keep clean, and who would rather retire a cramped enclosure or an unused tub than work around it for another decade.

1
Design & Layout
We measure the space and settle the decisions that are expensive to change later: curbed or curbless, where the drain runs, which way the glass opens, and where niches and a bench land so they sit within reach rather than wherever the tile pattern allowed.
2
Demo & Waterproofing
We open the wet area to the studs and assess what is actually behind it before rebuilding. The pan is set sloped and the walls are carried up in a continuous membrane, sealed at every seam, corner, and pipe penetration, then flood-tested before any tile is set.
3
Tile & Fixtures
Wall and floor tile go in over the waterproofed shell, followed by the valve and the heads you selected. This is also when we confirm the exhaust actually moves the volume the finished shower will produce, rather than the minimum the old fan was rated for.
4
Glass & Finish
Once tile is set and grouted, glass is measured to the finished opening rather than to plan dimensions, so the fit is tight. We seal, clean, and walk the completed shower with you.

Good to know

Walk-In Showers questions

Do I need a door, or can a walk-in shower stay open?: Many walk-in showers use a fixed panel with no door, which keeps the room open and removes a hinge to clean. The tradeoff is thermal rather than structural: an open entry lets warm, wet air into the rest of the bathroom, and in a marine climate that moisture has to be exhausted rather than left to settle on the finishes. We size the fan accordingly and plan the entry so water still lands where it should.
Is a frameless glass enclosure harder to maintain than framed?: Frameless is easier to keep clean because there is no metal channel for water and soap to collect in. What matters more here is your water: Camas runs on municipal groundwater and much of outlying Clark County is on private wells, and dissolved minerals are what leave the film people mistake for permanent clouding. A squeegee after use handles most of it, and a protective coating helps water sheet off.
What keeps a walk-in shower from leaking over time?: The waterproofing under the tile does the work, not the tile. Tile and grout are both water-permeable, so the membrane behind them is what actually protects the framing. That matters more in Clark County than in a dry climate, because a wall cavity that takes on moisture here has no hot, dry season in which to recover — Marine 4C keeps outdoor humidity high from late fall through spring.

Walk-In Showers by city